Table of contents: Removal ↓ Installation ↓
- Home
- BMW 7 Series
- E32
- Electrical equipment
- Equipment and devices
- Heating/Air Conditioning Control Unit — Removal and Installation
Heating/Air Conditioning Control Unit — Removal and Installation (BMW 7 Series E32)
Elements of the heating system
1 — heater fan;
2 - screw;
3 - stepless fan;
4 — cabin temperature sensor;
5 — heater temperature sensor;
6 - black vacuum hose;
7 - about laying the connection for outside air;
8 — ventilation fittings (nozzles);
9 — outside air damper control cable;
10 - cable in sheath;
11 - Fan cover;
12 — heater channel bushing;
13 — bracket;
14 — screw;
15 — heater body;
16 — heater housing cover;
18 — cable in a sheath for footwell (A — green, C — green), heated glass (A — red, C — red), ventilation (A — blue, C — blue);
19 — damper drive;
20 - control plate;
21 - front shield;
22 — air distribution handle;
23 — temperature control knob.
Removal
Release the control unit.
To do this, push in the two flat probes on the left and right, thereby pressing down the spring clips.
Remove the control unit.
Release and remove the plug.
To do this, press the mounting tabs down and fold the mounting bracket to the side, causing the switch to be pulled upward.
Release the other plugs by squeezing them.
Installation
Insert the plugs and secure them.
Install the multi-pin plug and secure it with the lever. Lock the lever. Check the tightness of the plug and the fastening lever.
Insert the control unit, press it evenly and secure it.
This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Article verified: Sevastyanov Nikolay
Share information:
Previous articles
БМВ E32: Equipment and devices
Next articles
Similar articles on other types of BMW cars:
Removal and installation the control unit BMW 3 Series E30 (1982-1994)
Removal and installation the DME control unit BMW 3 Series E36 (1990-2000)
Removal and installation the heating/air conditioning control unit BMW 5 Series E39 (1995-2003)
Removal and installation the electronic control unit (ECU) BMW 5 Series E28 (1981-1988)
Removal and installation the airbag control unit BMW X3 E83 (2003-2010)
Replacing the air conditioning control unit BMW X5 E53 (1999-2006)
Removal and installation the control unit BMW 3 Series E30 (1982-1994)
Removal and installation the DME control unit BMW 3 Series E36 (1990-2000)
Removal and installation the heating/air conditioning control unit BMW 5 Series E39 (1995-2003)
Removal and installation the electronic control unit (ECU) BMW 5 Series E28 (1981-1988)
Removal and installation the airbag control unit BMW X3 E83 (2003-2010)
Replacing the air conditioning control unit BMW X5 E53 (1999-2006)
Link in different formats to this page
Visitor comments
No comments yet
- General information
- Introduction to guide
- Manual
- Maintenance
- Power unit
- Engine M60/1, M60/2 (petrol)
- M62 engine (petrol)
- M57 engine (diesel)
- M67 engine (diesel)
- Cooling system
- Fuel system (petrol)
- Fuel system (diesel)
- Exhaust system
- Ignition and control systems
- Charge and launch systems
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Cardan and drive shafts
- Chassis
- Brake system
- Front suspension
- Rear suspension
- Steering
- Body
- Exterior
- Interior
- Electrical equipment
- Equipment and devices
- Lighting
- Heating and air conditioning
- Electrical circuits
- General information
- Care and maintenance
- Power unit
- Minor engine repair
- Engine overhaul
- Lubrication system
- Cooling system
- Ignition system
- Supply system
- Injection system (petrol)
- Injection system (diesel)
- Exhaust system
- Transmission
- Clutch
- Manual gearbox
- Automatic gearbox
- Cardan gear
- Rear axle and shafts
- Chassis
- Front suspension
- Rear suspension
- Steering
- Wheels and tires
- Brake system
- Body
- Body elements
- Electrical equipment
- Equipment and devices
- Electrical circuits
