2. Remove the upper section of the air filter housing along with the MAF sensor from the corresponding side (see chapter Power supply and exhaust systems).
3. When working with the left ignition distributor, release the clamps of the electrical wiring harness.
4. Wring out clamps and remove a protective cover.
5. Remove the interference suppression plug.
Remember or mark the I/O wire connections so you don't mix them up later.
6. Turn out bolts and remove a cover of the distributor of ignition, trying not to damage plates of a radiator.
7. Turn out bolts and remove a rotor of the distributor of ignition.