Removal and installation the rear bumper trim (from 09/2006)
1. Remove the cover from the side of the loading floor.
2. Unscrew the bolts (1) on the bumper trim (2).
3. Unscrew the bolts (1) and unscrew the nuts (2) on the left and right sides.
Note: Make sure that the wheel arch cover (3) is positioned correctly.
4. Slightly push the wheel arch protective cover to the side and unscrew the bolt (1) on the bumper trim (2) on the left and right sides.
5. Unscrew the bolts (1) on the bracket (2).
6. Unscrew the bolt (1).
7. Unscrew the nuts (2) and remove the bracket from the stud.
Attention:
- Risk of damage.
- Do not remove the bumper trim (1) from the side outwards.
8. Pull the bumper trim (1) by the side in the direction indicated by the arrow.
9. Using an assistant, pull out the bumper trim (1) in the direction indicated by the arrow and remove it.
Note: Equipped with Park Distance Control.
10. If necessary, slightly pull back the bumper trim (1) and disconnect the ultrasonic transducer connectors.
11. Installation should be carried out in the reverse order of removal, taking into account the above notes.
[You can read the original on the website «BMWMAN.ru»]