Withdrawal
1. Set the transmission to reverse gear. Raise the front of the car and place it on stands. Be sure to place chocks under the rear wheels to prevent rolling.
2. Pull the switch lever button up and out of the lever.
3. Remove the frame of the lever and the sound-absorbing material underneath.
4. Remove the rubber dust cover. On models with an aluminum shift housing, disconnect the reverse gear switch connector before removing the boot.
5. Working under the vehicle, disconnect from the switch stem (3) switch lever (2), by removing the fixing clip (1).
6. On models with a stamped steel shift housing, remove the circlip at the top of the shift lever bearing and remove the shift lever.
7. On models with an aluminum shift housing, insert two screwdrivers from under the lower bearing of the shift lever into the grooves of the bearing retaining ring. To unlock the ring, turn it a quarter of a turn counterclockwise and remove the switch lever.
Installation
Installation is reverse to removal procedure.