Withdrawal
Loosen wheel bolts.
Raise the front of the car, remove the wheel.
Loosen the steering knuckle nut. Press out the steering knuckle joint with a suitable puller.
Unclip tie-down 2 at steering end.
Unscrew tie rod end 3 from outer tie rod 1.
Attention: When unscrewing, note the number of turns. Note that the left side is a left-hand thread and the right-hand side is a right-hand thread.
Installation
Screw on the steering knuckle by the same number of turns.
Insert the tie rod into the steering linkage arm. Screw in a new self-locking nut with a tightening torque of 35-40 Nm.
Put the wheel on. Lower the car.
Tighten wheel bolts crosswise to 110 Nm.
Tighten the steering knuckle to 15 Nm. In this case, the car must be on the ground.
Adjust the convergence on the optical stand (at the service station).