Removal and installation rear wheel brake discs
1. Remove the wheels.
2. Remove and clean the brake pads.
3. Check the minimum thickness of the brake disc.
1) Place the 341280 device on three points in area (1) and take readings.
2) Compare the smallest of the obtained values with the given value.
Please note: Brake pads should only be replaced if the brake disc thickness is greater than or equal to the minimum thickness (MIN TH).
Attention:
- If the brake discs are replaced, new brake pads should also be installed.
- Brake discs should only be replaced in pairs (on both axle wheels).
4. Unscrew the bolt and remove the brake disc.
Note: When installing, it is necessary to replace the brake disc mounting bolt.
Tightening torque: 16 Nm.
Note: After completing the work, follow the instructions for running in new brake discs/pads.
5. Installation should be carried out in the reverse order of removal, taking into account the above notes.
6. Adjust the parking brake.
(The original article is available on the website BMWman.ru)