Removal and installation the door lock (BMW 5 Series E34)

Removal

Remove the inner door trim.

The window must be closed.



Unscrew block 1, tilt the glass guide strip forward and detach it from above.



Disconnect the connecting rod from the lock cylinder. To do this, move the locking pin to the side and pull the rod out of the lock lever.



Remove 3 bolts on the door. The rear bolt is located under the rubber seal.



Remove the lock from the door.

Installation

(Figure W - 48119) The rods must be connected to the lock as follows:

• 1 - to the lock button,
• 2 - to the door handle (lock cylinder),
• 3 - to remote control.

Insert the lock into the door and connect the rods accordingly. The rods have bends. The rods are inserted so that they do not touch the door anywhere. Ensure free movement of the rods.

Secure the lock to the door with 3 bolts.

Check the operation of the lock, remote control and central locking control.

Slide the glass guide from below into the upper hook, then screw it to the door. Insert the sealing rubber into the guide.

Install the interior door trim.