Withdrawal
Remove door glass.
Disconnect the electrical power window connector.
Remove guide -1-.
Mark the mounting position of the screws -arrows-. To do this, circle the screw heads with a felt-tip pen.
Loosen the 3 lower screws -arrows-.
Unscrew the top 3 screws -arrows-.
Remove window regulator -1- as an assembly.
Installation
Insert window lifter into mounting bracket and tighten all screws -2- slightly.
Tighten screws -1- and -2- to 10 Nm.
Insert the door glass into the clamps -arrows- of the power window and adjust.
Lower the window glass of the door as far as it will go down.
Tighten screws -3- and -4- to 10 Nm.
Raise the window glass of the door up to the stop.
Tighten screws -5- and -6- to 10 Nm.
Install guide.
Install door trim.