Withdrawal
Unfasten the cladding.
Pull the wiring harness out of the trunk lid. To do this, disconnect the connectors for the license plate light and the central locking system. Attach the binding cord to the plugs and pull out the wiring harness.
Attention: This keeps the tie-down cord in the luggage compartment lid and serves to facilitate subsequent assembly.
Mark the position of the rear lid at the hinges. To do this, circle the base of the hinge around the perimeter with a felt-tip pen.
Support the luggage compartment lid securely or have an assistant hold it.
Loosen screws -1- on left and right, unscrew screws -2-.
Remove the luggage compartment lid with an assistant.
Installation
Together with an assistant, attach the luggage compartment lid, tighten the screw -1-, but do not tighten.
Align the luggage compartment lid in accordance with the marks made before removal and tighten the fastening screws.
If a new trunk lid is fitted, it must be adjusted.
Using a tie cord, insert the wiring harness into the cover and connect the plug connectors of the license plate light and the central locking system.
Fasten the lining, replace the damaged clips with new ones.