Attention:
- Observe safety requirements when handling fire safety equipment.
- When handling the airbag unit, do not apply excessive force.
- To unlock the airbag unit, use only the specified tools.
- Improper handling may result in the airbag deploying and, as a result, injury to personnel.
Attention:
- After the airbag has been triggered, the steering wheel must be replaced.
- Follow the instructions for action after the airbag has been triggered.
1. Disconnect the negative battery cable.
2. Insert a Torx screwdriver (T30) horizontally into the hole on the back of the steering wheel until it stops (approximately 4.5 cm).
3. Press the spring lock (2) with a Torx T30 screwdriver (1) until the airbag unit is unlocked.
4. Do the same for the other side.
Note:
- When installing, it is necessary to pay attention to the correct wiring.
- Fix the airbag unit in the steering wheel. At the same time, keep the airbag unit parallel to the steering wheel and apply uniform force.
Attention: The NPB block may only be placed with the soft part (air cushion) up.
5. Tilt the airbag unit (1) slightly to the side.
6. Insert a screwdriver (2) from the front into both connectors (3) so that the cover lifts up.
7. Disconnect the connectors (3).
8. Remove the airbag unit (1).
Note: When installing, it is necessary to connect the connectors to the airbag unit in accordance with their color.
9. Installation should be carried out in the reverse order of removal, taking into account the above notes.
The original article is available on the website: «BMWman.ru»