Withdrawal
1. Disconnect the wire from the negative battery terminal (see chapter 5A).
2. Fully lower and pull out the steering column.
3. Remove the two hex head screws located on the top of the dashboard and carefully pry the top of the dashboard away from the bezel (pic. 9.3).
4. Raise the clips and disconnect the wiring connectors, then remove the dashboard from the car (pic. 9.4).
Installation
5. Installation is carried out in sequence. reverse withdrawal. Make sure all instrument panel wiring connectors are connected and secured with retainers. After installation, connect the battery and check the operation of the signal lamps.
Note. If you are installing a new dashboard, it must be coded. This procedure should be entrusted to a BMW dealer or specialist.