Home
BMW 7 Series
E32
Power unit
Minor engine repair
Cylinder head cover for M52 series petrol engines — removal and installation

Cylinder head cover for M52 series petrol engines — removal and installation (BMW 7 Series E32)

Table of contents: Removal ↓ Installation ↓

Removal

Remove the cover and disconnect the ignition coil connectors, while folding the metal brackets upward.

Unscrew the ignition coils from the cylinder head and remove them.

Remove the cylinder head cover bolts.

Note: Pay attention to the location of the rubber pads under the bolts for subsequent installation in the same place.

Installation

Replace damaged gaskets. When applying the gasket, pay special attention to the correct positioning of the cutouts in the front part of the cylinder head. Subsequent installation is carried out in the reverse order of removal. Evenly tighten the ignition coil and cylinder head cover bolts with a force of 10 Nm.

Connect the ignition coil connectors and secure them with metal brackets.

(The article text was copied from an online resource BMWMan.ru)

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article verified: Sevastyanov Nikolay

Share information:

БМВ E32: Minor engine repair

Minor repairs of M52 series petrol engines. General description
Valve clearances
Engine Mounting Brackets — Inspection and Replacement
Rear Crankshaft Oil Seal — Replacement
Flywheel/Drive Disc — Removal and Installation

Cylinder head of gasoline engines of the M52 series — removal and…
Valve clearances of gasoline engines of the M52 series
Cylinder head of the M70 series gasoline engine — removal and…
Cylinder head of diesel engine series M51 — removal and installation
Poly V-belt for diesel engine M51 series — replacement

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet