Attention! Make sure that there are no injector sealing rings in the injector installation channels.
Seal the hole in the injector channel using the "13.5.215" tool in combination with the "13.5.214" tool. Disconnect the "13.5.214" tool from the "13.5.215" tool (fig. 6.126) and remove the mounting rod from the injector channel. Insert the brush holder with the brush head of the "13.5.210" device into the guide sleeve and insert the "13.5.210" device into the injector channel until it stops.
Put on the socket wrench (fig. 6.127) onto the device "13.5.210" and turn it with a little force to fix it. Put on protective glasses and clean the side surfaces of the injector channel, pushing and pulling out the device "13.5.210".
Blow out the injector channel with compressed air, covering the hole with a damp cloth (gasoline B-70) with a cloth to collect dirt particles. Check the cleanliness of the sealing surface, if necessary, repeat the cleaning. After cleaning, remove the devices from the injector channel.