Read information from the memory of malfunctions of the ECU KSUD (DME). Switch off the ignition.
Attention! Do not place the middle part of the limber on the terminals of the forced start system. Do not kink the hood release cables.
Remove center front (end beam). Unlock and disconnect the loop (2, fig. 5.169) from system sensor «AUC». Release the sensor from the clamps (3) systems «AUC» and take him aside.
Raise the electric fan (4) in the direction indicated by the arrow. Drop the noose (5) fasteners in the direction indicated by the left arrow. Carefully squeeze out the hose (6) cooling systems aside. Remove the electric fan towards the top.
When installing, loop (1 and 5) attachment to the module bracket. When replacing the fan shroud, the system sensor must be removed «AUC» and replace it with a new casing. After completing the assembly of the engine, check the operation «DME» and clear the fault memory.