Hood, hinges, gas shock absorber and hood drive
1 - hood
2 - side seal
3 - rear seals
4 - gas-filled shock absorber
5 - loop left
6 - drive lever
7 - rear hood drive
8 - ball joint
9 - emphasis
10 - trunnion of the castle
11 - latch
12 - central hood drive
13 - hook support
14 - screw M6 x 35
15 - eccentric
16 - nut with washer
17 - hood lock
18 - side hood drive
19 - front cross member
Withdrawal
1. Disconnect the washer nozzle connector.
2. Disconnect the hose connection of the washer nozzles.
3. Mark the position of the loop -1- on the hood by tracing around the loop with a felt-tip pen.
4. Support the hood or have an assistant hold it.
5. Turn out a bolt -2 - at the left and on the right, weaken a bolt -3-.
6. Disconnect the mass cable -4- on the left loop.
7. Remove the hood with the help of an assistant.
Installation
8. Install the hood with the help of an assistant, screw in the bolts -2- without tightening them.
9. Expose a cowl according to the put marking and tighten bolts of fastening.
10. If the hood has been replaced with a new one, adjust it.