Removal and installation the front anti-roll bar
Caution: Secure the engine in its mounting position to prevent it from falling.
1. Disconnect both struts from the stabilizer bar.
2. Lower the front suspension crossmember.
3. Unscrew the screws (1).
4. Remove both clamps (2) and rubber-metal hinges (3).
5. Remove the stabilizer to the side through the wheel arch.
Note:
- When installing, it is necessary to check and, if there is any damage, replace both rubber-metal hinges (3).
- The clamps (2), hinges (3) and stabilizer must be clean from dirt and grease.
Tightening torque: 56 Nm.
6. Installation should be carried out in the reverse order of removal, taking into account the above notes.
7. Perform steering wheel angle sensor correction.