2. On vehicles with manual transmission, disengage the clutch (see chapter Clutch).
3. Where necessary, mark the position of the flywheel/drive plate in relation to the crankshaft so that it can be installed in the same position later.
4. The flywheel/drive plate is attached to the rear of the crankshaft with eight bolts.
5. Using a socket and ratchet, loosen the eight flywheel/drive plate mounting bolts to the crankshaft flange - hold the flywheel/drive plate from turning by locking the ring gear with a lever
6. Be careful - the flywheel is quite heavy.
7. To install the flywheel/drive plate onto the crankshaft, apply a special thread sealant to the bolts and tighten them gradually, moving diagonally, to the required torque.
8. Perform the rest of the installation procedure in the reverse order of removal.
The original text of the article is available on the resource: BMWMAN