2. If necessary, disconnect the supply line (1) of the clutch hydraulic system. On vehicles with a DSC booster pump, the supply line must be secured in a vertical position to prevent fluid from leaking out.
3. Remove the reservoir (2) from the brake master cylinder, rocking it in different directions. When installing, check the rubber plug in the brake master cylinder – it should not be damaged. Install the reservoir vertically on the brake master cylinder.
4. Loosen the brake pipe mounting nuts and plug the open holes in the pipes and the master cylinder.
5. Loosen the nuts and disconnect the brake master cylinder from the vacuum booster.
Use new self-locking nuts when installing.
6. Replace the sealing ring.
7. Installation is carried out in the reverse order. Finally, bleed the brake system.