2. Remove the top engine cover.
3. Remove the air cleaner top cover along with the MAF sensor (see Section Replacing the air cleaner element Chapters Vehicle settings and routine maintenance).
4. Remove plastic covers and ignition coils located under them.
5. Turn out fastening bolts and move left and right cable boxes to the middle.
6. Disconnect the wire from the positive contact of the battery in the engine compartment (see illustrations Engine compartment components).
7. Give fixture and remove a cover of a head of cylinders.
8. Check up a condition of a lining of a cover of a head of cylinders and if necessary replace a lining.
9. Clean sealing surfaces of gasket residue and lubricate mating surfaces with Drei Bond 1209 sealant.
Sealing locations
10. Establish a cover of a head of cylinders, center it on several bolts then tighten bolts of fastening of a cover with the demanded effort in sequence from the middle to edges.