Loosen clamps (1 and 2, fig. 13.60) covers. Move back (down arrow) corrugated case (3) and take off the glass (4) hinge (up arrow).
Remove retaining ring (1, fig. 13.61) and a three-pointed star (2) CV joint from splined shaft (3). Remove the bellows by sliding it over the splined shaft. Thoroughly clean all parts with a clean cloth.
Installation of the bellows should be carried out in the reverse order, while it is necessary to assemble the bellows together (1, fig. 13.62) and its adapter (2).
Three-beam asterisk (2, see fig. 13.61) install with the flat side facing the circlip. Install a new retaining ring. Lay in SHRUS (three-beam asterisk) new grease, which is included in the repair kit. Tighten the clamps with a special tool «1682».