Removing the lever (7, see fig. 16.10) the rear window wiper must be carried out in the following order. Prepare fixture «61.6.060».
Pry off the protective cap with a screwdriver (3) lever (7) side and remove it. Loosen the nut (4) wiper arm mounting. Using fixture «61.6.060» (1, fig. 16.33), disconnect the lever (2) wiper and remove it.
The installation of the rear window wiper arm should be carried out in the reverse order, while it is necessary to check that the latches of the protective cap (3, see fig. 16.10) had no damage.
The wiper motor must be in its end position. Adjust Distance (1, fig. 16.34) between the wiper arm and the lower edge of the rear window, which should be 32.5 mm±2 mm.
Nut (M8) lever fastenings should be tightened with a torque of 13.5 Nm (1.35 kgf·m).