Note: To prevent the lever drive motor from falling out, secure it with adhesive tape.
Disconnect the SS from the electric motor (1, see Fig. 16.10), unscrew the screws (2) and remove the windshield wiper motor.
The installation of the rear window wiper motor should be carried out in the reverse order, while it is necessary to replace the rubber bushing (6), paying attention to its position, the marking should be horizontal.
Insert the motor mounting screws and tighten them by hand. Center the windshield wiper motor and tighten the screws (M6) to a torque of 10 N·m (1.0 kgf·m).
Set the jet of washer fluid so that it hits the point (1, Fig. 16.35) with coordinates A = 100 mm and B = 450 mm.
Caution! Do not insert sharp objects into the injector nozzle due to the risk of damage.
Mark the point where the washer fluid jet hits the glass with a piece of adhesive tape. Adjust the nozzle by inserting an angled screwdriver with a 3.5 mm blade into the hole.
If necessary, replace the rear window washer nozzles using the "00.9.317" tool. After replacing the nozzle, it must be adjusted.