Attention! The precise angle setting of the wiper arms improves the performance of the wiper.
In the absence of a brush, it is necessary to install rubber tubes on the wiper arm or wrap the end of the arm with adhesive tape, this will help to avoid scratches on the glass.
Installing the wiper arms on the windshield and checking their position must be carried out in the following order. Prepare fixtures «00.9.221», «00.9.222» And «00.9.331». Install fixture «00.9.331» (pic. 16.26) on the windshield near the pivot point of the wiper blade. The presence of a gap between the caliber and the wiper blade at the top indicates a large angle of installation of the lever.
It should, holding the lever with a device «00.9.222» (pic. 16.27), turn it with a jig «00.9.221» in the direction indicated by the arrow.
The presence of a gap between the caliber and the wiper blade at the bottom indicates that the angle of the lever is too small. It should, holding the lever with a device «00.9.222», turn it with a jig «00.9.221» in the opposite direction.