Replacing the wiring harness branch to the fuel injection injectors must be carried out in the following order.
Remove the soundproof casing, the right air intake box, the rods in the engine compartment and the control electronics compartment cover.
Disconnect loops (1, fig. 6.136) from injectors. Remove bolts (2) and pull out the cable box upwards (3) from the mount. Open the clamps, set the control unit in a vertical position and disconnect the loops from it.
Remove the latch (1, fig. 6.137). Disconnect and remove the black loop (2) in bracket A and white loop (3) in bracket B. Remove the wiring harness branch to the injectors.
Installation of the wiring harness branch to the injectors should be carried out in the reverse order. Assemble the engine.
Read information from the system fault memory «DDE».