Removal and installation the generator (n52 K engine)
Attention:
- Do not use steel screws. Danger of electrochemical corrosion.
- For magnesium housings, use only aluminum screws.
- After unscrewing, aluminum screws must be replaced.
- You can distinguish aluminum screws by their blue ends.
- Strictly observe the tightening torque and angle.
1. Turn off the ignition.
2. Disconnect the negative cable from the battery.
3. Remove the air filter housing.
4. Remove the generator drive belt.
5. Unlock and disconnect the connector (1).
6. Unscrew the nut (2).
Tightening torque: 19 Nm.
7. Unscrew the bolts and remove the generator (3).
Note: Replace aluminum screws during installation.
Tightening torque: 10 Nm + 180°.
8. Installation should be carried out in the reverse order of removal, taking into account the above notes.
This article is based on information from the website: «BMWMAN»