Replacing the selector shaft (GA 6 L 45 R)
Attention:
- After completing the work, check the oil level.
- Use only certified brands of transmission oil.
- Violation of this rule leads to serious damage to the automatic transmission.
1. Remove the mechatronics.
2. Remove the selector shaft seal.
3. Remove the gearbox (only with all-wheel drive).

4. Drive a metal rod (1) with a diameter of approximately 3 mm into the expansion pin (2) (to prevent compression of the expansion pin).
5. Grasp the expansion pin (2) with side cutters and remove it from the blind hole.
Note: As per the picture.

6. Push the spacer pin (2) out of the selector shaft using a suitable tool.
7. Remove the selector shaft.
8. Installation should be carried out in the reverse order of removal, taking into account the above notes.
Information obtained from this online resource: «bmwman.ru»
