Prepare rubber plugs for the headlight washer hoses. Cut the bandage (1, Fig. 18.5) hose (2).
Unlock and disconnect the hose (3) and plug the hole (4) in the headlight washer pump.
Unscrew the bolts on the left and right sides and remove the side mudguard visors.
Hook up the pads (1 and 2, Fig.18.6) on the left and right side and remove them. If there is a "PDC" system (Parking Distance Warning), disconnect the ultrasonic transducer from the ultrasonic transducer (3) and remove the cover (2).
Open the hood and remove the bolts (1, Fig. 18.7) on the left and right sides. Unscrew the screws (5). Pull the bumper trim (2) slightly forward and disconnect the shock absorbers from the ultrasonic transducers (3) and fog lights (4). Disconnect the bumper trim (2) moving forward and place it on a clean mat.
Press the clamps and remove the front bumper mounting brackets on the left and right. Unscrew the mounting bolts and remove the license plate and its mounting shield.
Remove the optical elements of both fog lights (assembled). Remove the plate from the retainer and detach the decorative grille by moving it to the right and back. Remove the sheet nuts from the bumper trim. Remove the headlight washer nozzles, unhook their hose from the holders on the bumper trim and remove the nozzles.
When installing the cladding, it is necessary to replace damaged clamps (3, Fig. 18.8) on the crossbar (2). The clamps on the bracket and the hooks of the decorative grille cover must not be damaged.
Adjust the height of the gaps of the installed front bumper trim (see fig. 18.2).
