The replacement of the lower ball joint of the integral arm in the bearing support must be carried out in the following order. Prepare fixtures «33.3.333», «33.4.191», «33.4.192», «33.4.193» And «33.4.194» and remove the integral lever (4, see fig. 14.3). Support the wheel bearing support with a garage jack and remove the shock absorber from the rocker arm.
Remove retaining ring (1, fig. 14.45) and press out the ball joint using tools «33.3.333». «33.4.191», «33.4.192» And «33.4.193», while the splined side of the device «33.4.191» must face the wheel bearing support.
Using fixtures «33.3.333», «33.4.191», «33.4.192» And «33.4.193», press in the new integral arm ball joint (1, fig. 14.46) against the stop in the wheel bearing support and install a new retaining ring.
Measure the parameters of the rear axle.