The replacement of the cuff of the lower section of the steering shaft in the bulkhead must be carried out in the following order. Remove the lower section of the steering shaft and remove the cuff from the bulkhead.
When installing the cuff on a car with a left-hand drive, cover the edges of the cuff with silicone grease, while the arrow with the inscription «LHD» (2, fig. 12.39) on the cuff must match the arrow (1) on the front plate.
When installed on a right-hand drive vehicle, the arrow labeled «RHD» (2) on the cuff must match the arrow (1) on the front plate. Thread a new seal into the bulkhead and insert the plastic ring (3) into the cuff.
The replacement of the cuff of the lower section of the steering shaft in the bulkhead of auxiliary mechanisms must be carried out in a similar manner. At the same time, fill in a new cuff with an arrow (1, fig. 12.40) to the arrow in the partition of auxiliary mechanisms. Insert plastic ring (2) into the cuff.