The left intake camshaft position sensor is located on the cylinder head and must be replaced in the following order. Read information from the memory about malfunctions of the ECU-KCUD of the DME system. Switch off the ignition and remove the noise insulation cover.
Disconnect loop (1, fig. 4.129) from the left intake camshaft position sensor on the mounting plate.
Release the cable from the holder (2), unscrew the bolt (3) mounting the sensor on the engine cylinder head and remove the sensor (4) position of the left intake camshaft.
When installing the sensor, check the O-ring for possible damage and replace it if necessary. Lubricate the O-ring with petroleum jelly to facilitate sliding.
At the end of the replacement of the crankshaft position sensor, it is necessary to read information about malfunctions from the memory of the memory of the ECU-KSUD system «DME». Troubleshoot and erase information from the memory memory.