At the position "0" the ignition key, after pressing the corresponding function button, the time and date are displayed. After turning the key to position "1" time is displayed. Numeric values can be entered and changed.
Entering the time and date
After a power interruption (first entry, flashing dot) time can be set without first pressing the function button "UHR" using the input buttons "h/DAT" And "min/DAT".
To enter the date, first press the function button "DATUM".
Each time the enter button is pressed or held down, the numeric value increases by one every ½ second.
Mode "Watch" accompanied by the corresponding symbol, and the mode "date" - an inscription "DAT".
Switching on the indication mode with an accuracy of up to a second is done by pressing the button "UHR", start the calendar program - by pressing the button "DATUM". The dot will stop flashing.
Before entering new values, press the corresponding function button ("UHR" or "DATUM") until a flashing dot appears between hours and minutes (or between date and month).
If, after entry, the time or date display is not started and another function is selected, the old values are retained.
Wrong (unreal) values are not accepted by the program. When displaying the date, the leap year is not taken into account and must be manually corrected.
Instructions for 12 hour clocks
The change from AM to PM occurs at 12 o'clock and is indicated before the time indication. For the convenience of car owners in different countries, it is possible to switch to:
- 24-hour interval and°C;
- 12 hour interval and°F;
- 12 hour interval and°C.
on the case back. After switching from mode "24 hours" on mode "12 hours" the input button automatically switches from the indication "date - month" for indication "month - day".
Button "Memo"
This button toggles the rounded hour display on and off (to the whole). 15 seconds before each whole hour, a signal sounds, reminding, for example, when the tape recorder is turned on, the need to switch to the radio to listen to the latest news. The inclusion of the mode is accompanied by an indication of the letters "ME".
Outdoor temperature
By pressing the button "A-TEMP" the outdoor temperature is displayed. At temperatures below +3°C and from position "1" key in the ignition lock sounds a warning signal (road icing possible). At the same time, the unit symbol flashes for 10 seconds (°C/°F) and dot.
If at this time you turn on another mode and then return to the temperature display mode, only the optical warning will remain (flashing°С/°F symbol and dot) before the end of the 10 second period.
The low temperature warning is repeated if, since the last warning, the temperature has risen to +6°C and then drops back to +3°C.
Remember that the possibility of ice formation on the road surface is not ruled out even at temperatures above +3°C (e.g. on a bridge or on the shady side of the road).