Remove fan shroud, fan and alternator drive belt. Try on fixture «11.8.183» under the checkpoint (pic. 6.48).
Disconnect clamp (1) fastening the intake pipe from the gearbox, install the fixtures «11.8.183» And «11.8.182» for bolts (2) under the checkpoint. Adjust fixture position «11.8.182» by the crown (3) flywheel (drive disk).
Remove screws (1, see fig. 6.5) mounting of the vibration damper and remove it.
When installing the damper, install new bolts (M10) vibration damper fasteners and tighten them crosswise, in three steps:
- 1 torque reception 40.0 Nm (4.0 kgf·m);
- 2nd reception tighten by 60°;
- Turn 3 steps by another 60°.