Lower the front axle beam. Remove the bolts (1, Fig. 5.200), unscrew the upper fastening (3) of both engine mounting cushions, disconnect the jumper connection to the ground and unscrew the bolts (2) securing the engine support bearing bracket.
When installing the brackets, clean the contact surfaces to ensure reliable connection of the engine to the ground. Tighten the mounting bolts M8 (8.8) to a torque of 38 N·m (3.8 kgf·m), bolts M8 (10.9) to a torque of 30 N·m (3.0 kgf·m), nuts M10 (10.9) to a torque of 56 N·m (5.6 kgf·m).
The replacement of the right engine mount bracket must be carried out in the same way as the replacement of the left engine mount bracket.
(The original article is posted on the resource: «www.bmwman.ru»)