Loosen the engine mount mounting nuts. Raise the engine using the "11.0.000" tool by approximately 10 mm.
Set the steering gear to the middle position, the markings on the steering shaft and steering gear must match. Lower the front axle beam.
Loosen the bolts (1, Fig. 5.201) on the right engine mount cushion. Remove the engine mount cushion forward.
The installation of the right engine mount cushion should be carried out in the reverse order, while ensuring that the tide (1, Fig. 5.202) the cushions pointed towards the central axis of the car.
The markings on the mounting pads should be as follows:
- right engine mount cushion - even part number;
- left engine mount cushion - odd part number.
Tighten the engine mount bolts M8 (10.9) to a torque of 30 N·m (3.0 kgf·m), and the nuts M10 (10.9) to a torque of 56 N·m (5.6 kgf·m).
The left engine mount cushion is replaced in a similar manner, with the engine mount cushion being removed in a backwards motion.