Replacing the guide sleeve of the clutch release bearing installed on the manual transmission must be carried out in the following order. Remove gearbox. Remove the release bearing and release fork from the guide sleeve. Remove bolts (3, see fig. 8.31) guide bush fixings (2) and take it off.
When installing a new guide bush, remove the sticker and traces of glue on the bush, solvents such as acetone can be used.
When installing, tighten the M6x12 bolts for fastening the guide bush to a torque of 10 Nm (1.0 kgf·m), bolts M8x30 - torque 25 Nm (2.5 kgf·m).